Optimizing Firewall Policy Capacity
Firewall policy capacity depends on the number of rules and the sources, destinations, and services configured in the rules.
If a policy change reaches the supported capacity, address lists and service port lists can help reduce policy complexity while maintaining the same access requirements.
Optimize the policy
| If a rule contains | Do this | Example |
|---|---|---|
| Multiple IP address objects | Replace the objects with an address list that contains the same IP addresses. | Replace separate destination objects for
192.0.2.10, 192.0.2.20,
and 192.0.2.30 with one address list that
contains these addresses. |
| Multiple service objects that use the same protocol | Replace the objects with one service object that uses a port list. | Replace separate TCP services for ports 443,
8443, and 9443 with one
service that contains these ports. |
To create these objects, see:
Preserve your access requirements
When you optimize the policy:
- Keep the same addresses, protocols, and ports.
- Keep the rule's action, position, and logging settings.
- Use a range or subnet only if all included addresses or ports are required in the rule.
- Create new objects instead of modifying shared objects that other rules use.
Apply the changes and verify that the required traffic is allowed or blocked as intended.
If the policy still reaches its capacity, contact Check Point Support.