Safety Warnings for MHO-200

Installation Instructions

Read all installation instructions before you connect the equipment to the power source.

Bodily Injury Due to Weight

Use enough people to lift this product safely:

Risk of Electric Shock!

With the fan unit removed, power pins are accessible within the module cavity.

Do not insert tools or body parts into the fan unit cavity.

Over-temperature

Do not operate this equipment in an area with an ambient temperature that exceeds the recommended maximum: 45°C (113°F).

To guarantee proper cooling, allow at least 8 cm (3 inches) of clearance around the ventilation openings.

Stacking the Chassis

Do not stack the Chassis on any other equipment. If the Chassis falls, it can cause bodily injury and equipment damage.

Redundant Power Supply Connection - Electrical Hazard

This product includes a redundant power supply or a blank cover in its place.

In case of an empty power supply bay, do not operate this equipment with the blank cover removed, or not properly fastened.

Double Pole/Neutral Fusing

This Maestro Orchestrator has double pole/neutral fusing.

Remove all power cords before you open the cover of this product or touch any internal parts.

Multiple Power Inlets

The Power Supply Units are all independent.

Disconnect all power supplies to ensure a powered down state inside of this equipment.

During Lightning - Electrical Hazard

During periods of lightning activity, do not work on the equipment, connect or disconnect cables.

Connecting and Disconnecting of Copper Cables

Copper cables are heavy and not flexible. Therefore, carefully attach or detach them from the connectors.

Refer to the cable manufacturer for special warnings and instructions.

Rack Mounting and Servicing

When this product is mounted or serviced in a rack, you must take special precautions to ensure that the Maestro Orchestrator remains stable.

In general, fill the rack with equipment from the bottom to the top.

Equipment Installation

Only trained and qualified personnel should install, replace, and service this equipment.

Equipment Disposal

Dispose of this equipment in compliance with all national laws and regulations.

Installation Codes

Install this equipment according to the latest version of the country national electrical codes.

For North America, see the applicable requirements in the US National Electrical Code and the Canadian Electrical Code.

UL Listed and CSA Certified Power Supply Cord

For North American power connection, select a power supply cord that is UL Listed and CSA Certified, 3 - conductor [16 AWG], terminated with a molded plug rated at 125 V [13 A], with a minimum length of 1.5 m [6 feet], but no longer than 4.5m (15 feet).

For European connection, select a power supply cord that is internationally harmonized and marked "<HAR>", 3 - conductor, minimum 1.0 square mm wire, rated at 300 V, with a PVC insulated jacket. The cord must have a molded plug rated at 250 V, 10 A.

Interconnection of Units

Cables for connecting to the unit RS232 and Ethernet Interfaces must be UL certified type DP-1 or DP-2 (Note - When residing in non LPS circuit).

Overcurrent Protection

You must incorporate in the building wiring a readily accessible listed branch circuit overcurrent protective device rated 20 A.

Do Not Use the Switch as a Shelf or Work Space

Caution - Do not use the slide / rail mounted equipment as a shelf or a work space. The rails are not intended for sliding the unit away from the rack. It is for permanent installation at final resting place only, not used for service and maintenance.

WEEE Directive

According to the WEEE Directive 2002/96/EC, all waste electrical and electronic equipment (EEE) should be collected separately and not disposed of with regular household waste.

Dispose of this product and all of its parts in a responsible and environmentally friendly way.

Country of Norway Power Restrictions

This unit is intended for connection to a TN power system and an IT power system of Norway only.