Registration and Support

Registration

The appliance requires a product-specific Check Point license. Get a license and register at the Check Point Appliance Registration site.

The MAC address of the Management Interface is required to obtain a license.

To find the MAC address of the Management Interface in Gaia Clish:

1. Connect to the command line on the appliance - over SSH, or console.
2. Log in to the Gaia Clish with the administrator username and password.
3. Get the name of the Management Interface:

   show management interface

4. Get the MAC Address of the Management Interface:

   show interface <Name_of_MGMT_interface> mac-addr

5. Copy the MAC address from the screen.

To find the MAC address of the Management Interface in Gaia Portal:

1. In your web browser, connect to the management IP address: https://<appliance_ip_address>
2. Log in to the Gaia Portal of the appliance with the administrator username and password.
3. In the top left corner, in the View mode field, select Advanced.
4. In the left navigation tree, click Network Management > Network Interfaces.
5. The Management Interface section at the bottom shows the name of the Management Interface.
6. In the Interfaces section at the top, select the Management Interface.
7. From the toolbar, click Edit.
8. In the caution pop-up window, click OK:

   You are about to change the settings of an interface you are connected to. Click OK to proceed, Cancel to return.

9. Click th Ethernet tab.
10. Copy the MAC address from the Hardware Address field.
11. Click Cancel.

Support

For additional technical information about Check Point products, consult the Check Point Support Center.

Where To From Here?

You have the basics to get started. The next step is to get more advanced knowledge of your Check Point software.