set cluster site-id <Site ID> module

This command is supported only on:

Note - You must run this command in Gaia gClish.

Description

Configures cluster settings - hardware components on Scalable Chassis.

Syntax

set cluster site-id <Site ID> module<ESC><ESC>

set cluster site-id <Site ID> module <Module>

ip <IP Address>

ports_amount <Number>

secondary_ip <IP Address>

snmp_auth <Authentication Method>

status {active | down}

username <Username>

Parameters

Parameter	Description
`<Site ID>`	Specifies the Site ID: `1` - Site #1 `2` - Site #2 `all` - All Sites
`<Module>`	Specifies the hardware module: `CMM` - CMMs `SSM1` - SSM #1 `SSM2` - SSM #2 `SSM3` - SSM #3 `SSM4` - SSM #4 `Mgmt` - Management Ports
`ip <IP Address>`	Configures the primary IP address. Applies only to the SSM modules.
`ports_amount <Number>`	Configures the number of ports. Applies only to the SSM and Management Ports modules.
`secondary_ip <IP Address>`	Configures the secondary IP address. Applies only to the CMM modules.
`snmp_auth <Authentication Method>`	Configures the SNMP Authentication method: `MD5` (this is the default) `SHA1` `none` Applies only to the SSM and Management Ports modules.
`status {active \| down}`	Configures the status. Applies only to the SSM and Management Ports modules.
`username <Username>`	Configures the internal username. Default: `asg1` Applies only to the SSM and Management Ports modules.

Related Commands