Logging into Endpoint Web Management Console

  1. Install an Endpoint Security Management Server

    See the R81.20 Installation and Upgrade Guide > Chapter Installing an Endpoint Server > Section Installing an Endpoint Security Management Server.

  2. Connect with SmartConsole to the Endpoint Security Management Server
  3. Enable the required Software Blades
    1. From the left navigation panel, click Gateways & Servers
    2. Open the Endpoint Security Management Server object
    3. On the Management tab, select these Software Blades

      • Endpoint Policy Management

      • SmartEvent Server - Required for the Security Overview tab only.

    4. Click OK
  4. Install the database
    1. Click Menu > Install database
    2. Select the Endpoint Security Management Server
    3. Click Install
  5. Start the Endpoint Web Interface
    1. Connect to command line on the Endpoint Security Management Server
    2. Log in to the Expert mode
    3. Run 
      web_mgmt_start
  6. Connect to Endpoint Web Management Console

    Connect to Endpoint Web Management Console in one of these ways:

    • In SmartConsole, click Menu > Endpoint > Endpoint Security Web UI.

    • Connect with a web browser to:

      https://<Main IP Address of Endpoint Security Management Server Object>/sba/index.html

      Log in with the same credentials you use to log in to SmartConsole.

      Note:

      The default port is 443. If you have upgraded from R80.40 or older, then the default port is 4434. If you have changed default port, then use the updated port number.

      https://<Main IP Address of Endpoint Security Management Server Object>:<port number>/sba/index.html