Upgrading one Multi-Domain Server from R80.20 and higher with Advanced Upgrade

In an advanced upgrade scenario, you perform the upgrade procedure on the same Multi-Domain Server.

Notes:

  • This procedure is supported only for servers that run R80.20.M1, R80.20, R80.20.M2, R80.30, R80.40, or R81.

  • For additional information related to this upgrade, see sk163814.

Important - Before you upgrade a Multi-Domain Server:

Step

Instructions

1

Back up your current configuration (see Backing Up and Restoring).

2

See the Upgrade Options and Prerequisites.

3

Only the latest published database revision is upgraded.

If there are pending changes, we recommend to Publish the session.

4

If there are Global Policies configured on the Global Domain:

  1. Connect with SmartConsole to the Global Domain on your source Multi-Domain Server.

  2. Reassign all Global Policies to all applicable Domains.

Important - Do not publish any changes in the Global Domain until you complete the upgrade to the next available version. This is necessary to avoid any potential issues caused by different policy revisions on the Global Domain and on other Domains.

5

You must close all GUI clients (SmartConsole applications) connected to the source Multi-Domain Server.

6

Install the latest version of the CPUSE from sk92449.

Note - This is to make sure the CPUSE is able to support the required Upgrade Tools package.

7

Run the Pre-Upgrade Verifier on all source servers and fix all detected issues before you start the upgrade.

8

In Management High Availability, make sure the Primary Multi-Domain Server is upgraded and runs, before you start the upgrade on other servers.

Procedure: