Open Frames Download Complete PDF Send Feedback Print This Page

Previous

Next

Reset SIC for non-VS0 Virtual Systems

To reset SIC on Virtual Systems that are not VS0 (a non-VSX object).

  1. Log into the SMO with a SSH client.
  2. Go the Expert mode.
  3. Run this command to go to the applicable context ID:

    vsenv <vsid>.

  4. Run this command to initialize SIC:

    # g_cpconfig sic init

  5. Revoke the VSID certificate defined in the management server.
  6. See Part II of sk34098 for the detailed procedure.
  7. In SmartDashboard, open and then save Virtual System object. This action "pushes" the configuration to the management server and re-establishes SIC trust with the SMO.
  8. Install a policy on the Virtual System.
 
Top of Page ©2014 Check Point Software Technologies Ltd. All rights reserved. Download Complete PDF Send Feedback Print