Disable Capabilities

Disable Capabilities allows users to turn on or turn off capabilities, such as Threat Prevention, Compliance, and so on in the Endpoint Security client.

Note:

If the Endpoint Security Client device is restarted, the option to enable or disable the capabilities will only be available after five minutes.

  1. Go to Policy > Client Settings > General > Disable Capabilities.
  2. Select the capabilities that can be disabled by the user on the client.
  3. To enable the disabled capabilities automatically after a set interval of time:
    Note:

    This is supported only on Windows with Endpoint Security client version E88.30 and higher.

    1. Select the Set timeout checkbox.
    2. In the timeout field, enter the time in minutes.
  4. To allow users to disable the capabilities only after entering a password, select the Protect by password checkbox.
    Note:

    This is supported only on Windows with Endpoint Security client version E88.30 and higher.

    1. Click Manage Disable Capabilities Protect Password.
      Note:

      Optionally, from the taskbar, click Manage and select the Manage Disable Capabilities Protect Password from the list.

    2. In the Password field, enter a password and re-enter the password in the Confirm Password field.
      Note:

      Make sure the password is at least eight characters long, without spaces, and includes:

      • An uppercase letter

      • A lower case letter

      • A number.

    3. Click OK.
  5. Click Save & Install.