User Interface

Default Client User Interface

You can select the default Endpoint Security client interface settings or edit them to customize the Endpoint Security client interface on user computers.

You can change these settings:

  • Display client icon - When selected, the client icon shows in the windows notification area when the Endpoint Security client is installed.

  • New client User Interface - Select an interface for the client.

    • Default - Applies the default interface specified in the client. Default is the new UI.

    • On - Applies the new interface.

    • Off - Applies the legacy interface.

  • Client language - Select the default language for client. OS Locale indicates the default OS language.

    Note:

    If the default language is not supported by the client, then system uses the English language for the client.

  • Notification level - You can decide which type of messages can be shown to the user, and which must not be visible. The administrator can select one of three options:

    • Critical only - Do not show any messages unless critical (e.g. system boot warning) or user interface messages (yes/no questions).

    • When-affecting user experience (recommended) - Only show messages related to operation flows affecting user activity, or requiring user interaction (e.g. "Malware was detected and removed").

    • All - Show all messages.

    Note: This change applies to the Endpoint Security Client only. Events are still being logged on the server, and the administrator can still see everything on the management interface.