Smart-1 Appliances Hardware

1

Line card

Four 10/100/1000Base-T RJ-45 ports.

See Front Panel Port LEDs. Use these ports to connect:

• The appliance to the network.
• To the appliance from the network.

The appliance comes equipped with this line card. Only this card is supported.

Installing other line cards will corrupt the network configuration.

2

Dummy panel

Reserved for future use. Installing line cards is not supported.

3

Reset button

Insert a pin to perform a hardware reset on the appliance.

4

Management configuration port

For an connection to a computer that does the initial configuration of this appliance. The interface name is MGMT.

5

Console port

An RJ45 port. For a serial connection to the appliance using a terminal emulation program such as PuTTY.

6

USB ports

Two USB 2.0 ports.

7

System power

Green when power is on.

8

Hard disk activity

Blinking red when there is read/write activity.

1

Management port

For an Ethernet connection to a computer that does the initial configuration of this appliance. The interface name is Mgmt.

2

Ethernet Ports

Network interfaces.
The interface names from left to right are eth1-01, eth1-02 up to eth1-04. The ports are numbered 1 to 4.

3

Port activity LED

• Off - No activity
• On (Green) - Link exists
• Blink (Green) - Activity

4

Link speed LED

• Off - 10 Mbit/s data rate is selected
• On (Green) - 100 Mbit/s data rate is selected
• On (Amber) - 1000 Mbit/s data rate is selected

1

Main power switch

2

AC power supply and fan

Connect to an electric outlet.

3

Fixed cooling fans

They are numbered from left to right: 1,2,3.