Configuring NAT Pools in Gaia Clish

Important - In a Cluster Two or more Security Gateways that work together in a redundant configuration - High Availability, or Load Sharing., you must configure all the Cluster Members in the same way.

• To see the available "set" commands for NAT Pools, enter in Gaia Clish The name of the default command line shell in Check Point Gaia operating system. This is a restricted shell (role-based administration controls the number of commands available in the shell).:

  set nat-pool[Esc][Esc]

• To see the available "show" commands for NAT Pools, enter in Gaia Check Point security operating system that combines the strengths of both SecurePlatform and IPSO operating systems. Clish:

  show nat-pool[Esc][Esc]

Action plan

1. Configure the applicable NAT Pools:

   See the Syntax section below.

2. Redistribute the applicable NAT Pools to the applicable dynamic routing protocols.

   See:

   • Configuring IPv4 Route Redistribution in Gaia Clish.

   • Configuring IPv6 Route Redistribution in Gaia Clish.

3. Configure the applicable Route Maps that match the applicable NAT Pools.

   See Configuring Route Maps in Gaia Clish.