Configuring IPv6 Route Redistribution in Gaia Clish

Important - In a Cluster Two or more Security Gateways that work together in a redundant configuration - High Availability, or Load Sharing., you must configure all the Cluster Members in the same way.

You can configure IPv6 route redistribution in Gaia Clish The name of the default command line shell in Check Point Gaia operating system. This is a restricted shell (role-based administration controls the number of commands available in the shell)..

• To see the available "set" commands for IPv6 Route Redistribution, enter in Gaia Check Point security operating system that combines the strengths of both SecurePlatform and IPSO operating systems. Clish:

  set ipv6 route-redistribution[Esc][Esc]

• To see the configured IPv6 Route Redistribution, enter in Gaia Clish:

  show configuration ipv6 route-redistribution[Esc][Esc]

General Syntax

set ipv6 route-redistribution to <Destination Protocol> <Destination Protocol Parameters> from <Source Protocol> <Source Protocol Parameters>

These are the destination options

• OSPFv3

• RIPng

Each destination protocol has a set of destination protocol parameters.

These are the source options

• BGP

• OSPFv3

• OSPFv3 External

• RIPng

• NAT Pools

You can also redistribute

• Routes from specific interfaces

• Static routes