Viewing Cluster IP Addresses

Description

This command shows the IP addresses and interfaces of the ClusterClosed Two or more Security Gateways that work together in a redundant configuration - High Availability, or Load Sharing. Members.

Syntax to see all interfaces

Shell

Command

Gaia ClishClosed The name of the default command line shell in Check Point Gaia operating system. This is a restricted shell (role-based administration controls the number of commands available in the shell).

show cluster members ips

Expert mode

cphaprob tablestat

Syntax to see only the monitored interfaces

Shell

Command

GaiaClosed Check Point security operating system that combines the strengths of both SecurePlatform and IPSO operating systems. Clish

show cluster members monitored

Note - This command is available in the R81.10 Jumbo Hotfix Accumulator, Take 75 and higher.

Expert mode

cphaprob -m tablestat

Example

Note - To see name of interfaces that correspond to numbers in the "Interface" column, run the fw ctl iflist command.

 
[Expert@Member1:0]# cphaprob tablestat
 
----   Unique IP's Table  ----
 
Member          Interface       IP-Address
------------------------------------------
 
(Local)
0               1               192.168.3.245
0               2               11.22.33.245
0               3               44.55.66.245
 
1               1               192.168.3.246
1               2               11.22.33.246
1               3               44.55.66.246
 
------------------------------------------
 
 
[Expert@Member1:0]#
[Expert@Member1:0]# fw ctl iflist
1 : eth0
2 : eth1
3 : eth2
[Expert@Member1:0]#