Installing CloudGuard Controller

1

Install the Gaia Operating System:

• Installing the Gaia Operating System on a Check Point Appliance
• Installing the Gaia Operating System on an Open Server

2

Run the Gaia First Time Configuration Wizard.

3

During the First Time Configuration Wizard, you must configure these settings:

• In the Installation Type window, select Security Gateway and/or Security Management.
• In the Products window:
  1. In the Products section, select Security Management only.
  2. In the Clustering section, in the Define Security Management as field, select Primary.
• In the Security Management GUI Clients window, configure the applicable allowed computers:
  • Any IP Address - Allows all computers to connect.
  • This machine - Allows only the single specified computer to connect.
  • Network - Allows all computers on the specified network to connect.
  • Range of IPv4 addresses - Allows all computers in the specified range to connect.

1

Connect to the command line on the Security Management Server.

2

Log in to the Gaia Clish, or Expert mode.

3

Run:

cloudguard on