Advanced Configuration

daemon-enable {on | off}

Enables or disables the Gaia Portal web daemon.

• Range: on, or off
• Default: on

session-timeout <Timeout>

Configures the time (in minutes), after which the HTTPS session to the Gaia Portal terminates.

• Range: 1 - 720
• Default: 15

ssl-port <Port>

Configures the TCP port number, on which the Gaia Portal can be accessed over HTTPS.

• Range: 1 - 65535
• Default: 443

Use this command for initial configuration only.

Changing the port number on the command line may cause inconsistency with the setting defined in SmartConsole. Use SmartConsole to set the SSL port for the Portal.

Note - This setting does not affect HTTP connections. Normally this port should be left at the default 443. If you change the port number, you will have to change the URL used to access the Gaia Portal
from https://<Hostname or IP Address>/
to https://<Hostname or IP Address>:<PORTNUMBER>

ssl3-enabled {on | off}

Enables or disables the HTTPS SSLv3 connection to Gaia Portal.

• Range: on, or off
• Default: off

table-refresh-rate <Rate>

Configures the refresh rate (in seconds), at which some tables in the Gaia Portal are refreshed.

• Range: 10 - 240
• Default: 10