Contents

Copyright Notice  Important Information  ClusterXL Administration Guide  Terms     3rd party Cluster     Active     Active     Active Up     Active(!)     Active/Active Mode     Active/Standby Mode     ARP Forwarding     Backup     Blocking Mode     Bond     Bonding     Bridge Mode     Cluster     Cluster Control Protocol (CCP)     Cluster Correction Layer (CCL)     Cluster Interface     Cluster Member     Cluster Mode     Cluster Topology     ClusterXL     CPHA     Creating an Interface Bond in Load Sharing Mode     Critical Device     Dead     Decision Function     Delta Sync     Delta Sync Retransmission     Down     Dying     Failback     Failed Member     Failover     Failure     Flapping     Flush and ACK     Forwarding     Forwarding Layer     Full High Availability Mode     Full Sync     HA not started     High Availability Mode     HTU     Hybrid Mode     Init     IP Tracking     IP Tracking Policy     Link Aggregation     Load Sharing Mode     Load Sharing Multicast Mode     Load Sharing Unicast Mode     Management Server     Master     Network Objective     Non-Blocking Mode     Non-Monitored Interface     Non-Sticky Connection     Packet Selection     Pingable Host     Pivot Member     Pnote     Preconfigured Mode     Primary Up     Private Interface     Probing     Problem Notification     Ready     Security Gateway     Security Management Server     Selection     SmartConsole     SmartDashboard     Standby     State Synchronization     Sticky Connection     Subscribers     Sync Interface     Synchronization Network     Traffic     VLAN     VLAN Trunk     VMAC  Introduction to ClusterXL  ClusterXL Requirements and Compatibility  High Availability and Load Sharing in ClusterXL  Synchronizing Connections in the Cluster  Configuring ClusterXL  Advanced Features and Procedures  ClusterXL Configuration Commands  Monitoring and Troubleshooting Clusters  Command Line Reference  ClusterXL Scripts  Working with Kernel Parameters on Security Gateway  Kernel Debug on Security Gateway