fw -i

Description

By default, the fw commands apply to the entire Security Gateway. The fw commands show aggregated information for all CoreXL FW instances.

The fw -i commands apply to the specified CoreXL FW instance.

Syntax

fw -i <ID of CoreXL FW instance> <Command>

Parameters

Parameter	Description
`<`ID of CoreXL FW instance`>`	Specifies the ID of the CoreXL FW instance. To see the available IDs, run the command `fw ctl multik stat`.
`<`Command`>`	Only these commands support the `fw -i` syntax: `fw -i <`ID`> conntab ...` `fw -i <`ID`> ctl get ...` `fw -i <`ID`> ctl leak ...` `fw -i <`ID`> ctl pstat ...` `fw -i <`ID`> ctl set ...` `fw -i <`ID`> monitor ...` `fw -i <`ID`> tab ...` For details and additional parameters for any of these commands, refer to the corresponding entry for each command.

Parameter

Description

<ID of CoreXL FW instance>

Specifies the ID of the CoreXL FW instance.

To see the available IDs, run the command fw ctl multik stat.

<Command>

Only these commands support the fw -i syntax:

For details and additional parameters for any of these commands, refer to the corresponding entry for each command.

Example - Show the Connections table for CoreXL FW instance #1

fw -i 1 tab -t connections