Monitoring RAID Synchronization

In R80.20, you can monitor the RAID status of the disks to see when the hard disks are synchronized. If you reboot the appliance before the hard disks are synchronized, the synchronization starts again at the next boot.

Showing RAID Information - Gaia Portal

In the navigation tree, click Maintenance > RAID Monitoring.

You can see the information about RAID Volumes and RAID Volume Disks.

Showing RAID Information - Command Line

Run one of these commands in Gaia Clish or Expert mode:

• raid_diagnostic

  This shows data about the RAID and hard disks, with the percent synchronization done.

  Example output from a Smart-1 225 appliance:

  

  • DiskID 0 is the left hard disk.
  • DiskID 1 is the right hard disk.
• cpstat os -f raidInfo

  This shows almost the same information as the raid_diagnostic command, in tabular format.

  Example output: