Important - You must configure all the Cluster Members in the same way.
Description
You can add a user-defined critical device to the default list of critical devices. Use this command to register <device> as a critical process, and add it to the list of devices that must run for the Cluster Member to be considered active. If <device> fails, then the Cluster Member is seen as failed.
If a Critical Device fails to report its state to the Cluster Member in the defined timeout, the Critical Device, and by design the Cluster Member, are seen as failed.
Define the status of the Critical Device that is reported to ClusterXL upon registration. This initial status can be one of these:
Syntax
Shell |
Command |
---|---|
Gaia Clish |
|
Expert mode |
|
Notes:
0
.-p
flag makes these changes permanent. After you reboot the Cluster Member, the status of critical devices that were registered with this flag is saved.-g
flag applies the command to all configured Virtual Systems.Restrictions: