Print Download PDF Send Feedback

Previous

Next

Installing R80.10 with the vSEC Controller

In This Section:

Upgrading the vSEC Controller on the Security Management Server

Supported Security Gateways

If you do not have the vSEC Controller, install R80.10 or upgrade the Security Management Server from an earlier version. See the R80.10 Installation and Upgrade Guide.

Upgrading the vSEC Controller on the Security Management Server

Upgrading R80 to R80.10

To upgrade the vSEC Controller v1 and v2 for R80 to R80.10, see sk111841 for upgrade instructions.

Important Information

  1. When you upgrade the vSEC Controller to R80.10 the following files are overwritten with default values:
    • vSEC Controller v1
      • vsec.conf (found in $VSECDIR/conf)
    • vSEC Controller v2
      • vsec.conf (found in $VSECDIR/conf)
      • tagger_db.C (found in $MDS_FWDIR/conf)

    Before you begin the upgrade, back up any files that you have changed.

  2. A Multi-Domain Server that contains imported Data Center objects in the Global Domain is not supported in the upgrade to R80.10. You must remove objects from the Global Domain before you install the upgrade.
  3. Before you perform the upgrade on the Management server, if you have a Cisco APIC server, keep only one URL. After the upgrade, add the other URLs.
  4. For upgrades from the vSEC Controller v1, manually connect again to each Data Center Server. For those servers that communicate with HTTPS, in SmartConsole double-click the Data Center object and trust the certificate again.

Note - During the upgrade, the vSEC Controller does not communicate with the Data Center. Therefore, Data Center objects are not updated on the Security Management Server or the Security Gateways.

Upgrading R77.30 to R80.10

For information on upgrading to R80.10, contact Check Point support.