Print Download PDF Send Feedback

Previous

Next

Monitoring Memory Resources (fw vsx mstat)

Use the fw vsx mstat command to monitor the memory the VSX Gateway uses. The command shows an overview of the memory that the system and each Virtual Device is using. These are the global memory resources that are shown:

The Virtual Devices are listed according to the VSIDs. Run vsx stat -v to show the VSID for the Virtual Devices.

You must be in expert mode to run the fw vsx mstat command. After you enable memory resource monitoring, it is necessary to reboot the VSX Gateway to use the feature.

Included Topics

Managing fw vsx mstat

Memory Resources for Each Virtual Device

Configuring Swap-in Sample Rate

Using Debug Mode

Managing fw vsx mstat

Use the fw vsx mstat command to enable or disable memory resource monitoring on the VSX Gateway.

Syntax

fw vsx mstat {enable|disable|status}

Parameter

Description

enable

Enables memory resource monitoring. Reboot the VSX Gateway.

disable

Disables memory resource monitoring.

status

Shows if memory resource monitoring is enabled or disabled.

Example

fw vsx mstat disable

Output

VSX memory resource control status: disabled