Print Download PDF Send Feedback

Previous

Next

ClusterXL Commands

In This Section:

cphaconf

cphaprob

cphastart

cphastop

cphaconf

Description The cphaconf command configures ClusterXL.

Important - Running this command is not recommended. It should be run automatically, only by the Security Gateway or by Check Point support. The only exception to this rule is running this command with set_cpp option, as described below.

Usage

cphaconf [-i <computer id>] [-p <policy id>] [-b <db_id>] [-n <ClusterXL num>] [-c <ClusterXL size>] [-m <service >] [-t <secured IF 1>...] start

cphaconf [-t <secured IF 1>...] [-d <disconnected IF 1>...] add
cphaconf clear-secured
cphaconf clear-disconnected
cphaconf stop
cphaconf init
cphaconf forward <on|off>
cphaconf debug <on|off>
cphaconf set_ccp <broadcast|multicast>
cphaconf mc_reload
cphaconf debug_data

cphaconf stop_all_vs

Syntax

Parameter

Description

set_ccp <broadcast|multicast>

Sets whether ClusterXL Control Protocol (CCP) packets should be sent with a broadcast or multicast destination MAC address. The default behavior is multicast. The setting created using this command will survive reboot.

Note: The same value (either broadcast or multicast) should be set on all ClusterXL members.

stop_all_vs

Stops the ClusterXL product on all Virtual Systems on a VSX Gateway.