Open Frames Download Complete PDF Send Feedback Print This Page

Previous

Next

Set Port Speed

You can set the port speed for one interface port or a comma-separated list of ports.

# asg if -i eth1-01,eth2-01 set_speed 10000
You are about to perform port speed change to 10000 on eth1-01 eth2-01 on blades: all


Are you sure? (Y - yes, any other key - no) y

Port speed change to 10000 on eth1-01 eth2-01 requires auditing
Enter your full name: y
Enter reason for port speed change to 10000 on eth1-01 eth2-01 [Maintenance]: y
WARNING: Port speed change to 10000 on eth1-01 eth2-01 on blades: all, User: y, Reason: y
Interface eth1-01 speed was set to 10G
Interface eth2-01 speed was set to 10G
 
Top of Page ©2014 Check Point Software Technologies Ltd. All rights reserved. Download Complete PDF Send Feedback Print