Open Frames Download Complete PDF Send Feedback Print This Page

Previous

Next

Connecting to a specific SGM (blade)

When you connect to the 61000/41000 Security System, you are actually connected to one of the SGMs. You can use the blade command to open a connection to a different Security Gateway Module. You must run blade in the Expert mode, which establishes a new SSH connection over the Sync interface.

Syntax

blade [<chassis_id>_]<sgm_id>

Example

# blade 1_03

Output

Moving to blade 1_3

Notes

  • When you only enter the SGM ID, the default Chassis is assumed.
  • To go back to the last SGM, enter exit.
  • You can run more than one blade command to open many SSH sessions.
 
Top of Page ©2014 Check Point Software Technologies Ltd. All rights reserved. Download Complete PDF Send Feedback Print