Verbose mode
The verbose mode shows extended information, including information retrieved from the switch. You can use the verbose mode for one interface or a comma-separated list of interfaces. This operation can take a few seconds for each interface.
# asg if -i eth1-01 -v
Collecting information, may take few seconds
+----------------------------------------------------------------------------------------+
|Interfaces Data |
+----------------------------------------------------------------------------------------+
|Interface|IPv4 Address |Info |State |Speed |MTU |Duplex |
| |MAC Address | |(ch1)/(ch2) | | | |
| |IPv6 Address (global)| | | | | |
| |IPv6 Address (local) | | | | | |
+---------+---------------------+------------+--------------+--------+----------+--------+
|eth1-01 |- |Bond slave |(up)/(up) |10G |1500 |Full |
| |00:1c:7f:a1:01:0 | |master: | | | |
| |- | |bond1(up)/(up)| | | |
| |- | | | | | |
+---------+---------------------+------------+--------------+--------+----------+--------+
|Comment |
+----------------------------------------------------------------------------------------+
|internal interface |
+----------------------------------------------------------------------------------------+
|Traffic |
+----------------------------------------------------------------------------------------+
|media |In traffic |In pkt(uni/mul/brd)|Out traffic |Out pkt(uni/mul/brd) |
+-----------------+-----------+-------------------+---------------+----------------------+
|FTLF8528P2BNV-EM |28.8Kbps |0pps/38pps/5pps |4.1Mbps |0pps/355pps/0pps |
+----------------------------------------------------------------------------------------+
|Errors (total/pps) |
+----------------------------------------------------------------------------------------+
|OutDiscards |InDiscards |InErrors |OutErrors |
+-----------------------------+-------------------+---------------+----------------------+
|0/0 |0/0 |0/0 |0/0 |
+-----------------------------+-------------------+---------------+----------------------+
|