Open Frames Download Complete PDF Send Feedback Print This Page

Previous

Next

Diagnostic Events

We recommend that you run the asg diag verify diagnostic tests on a regular basis. Alerts are sent if there are failed tests. The alerts continue with the Message of the Day (MOTD) until the issues are resolved. You can optionally disable the MOTD.

When the issues that caused failed tests are resolved, a "Clear Alert" message is sent the next time that the test runs. You can also run asg diag verify manually, to make sure that the issue is resolved.

By default, the tests run daily at 01:00. You can change the default time.

By default, all tests are run. You can exclude specified tests.

To change the time tests are automatically:

  1. Open /var/opt/CPsuite-R76/fw1/conf/asgsnmp.conf in a text editor.
  2. Change the asg_diag_alert_wrapper= parameter as necessary.
  3. Copy this file to all other SGMs:

    > asg_cp2blades <file_path>

To disable the MOTD:

  1. Open /var/opt/CPsuite-R76/fw1/conf/asg_diag_config in a text editor.
  2. Add this line to the file:

    motd=off

  3. Copy this file to all other SGMs:

    > asg_cp2blades <file_path>

To exclude specified tests:

  1. Open /var/opt/CPsuite-R76/fw1/conf/asg_diag_config in a text editor.
  2. Add this line to the file:

    excluded_tests=[<Test1>][,<Test2>,...]

  3. Copy this file to all other SGMs:

    > asg_cp2blades <file_path>

 
Top of Page ©2014 Check Point Software Technologies Ltd. All rights reserved. Download Complete PDF Send Feedback Print