Index
A
B
C
D
E
F
G
H
I
J K L
M
N
O
P
Q
R
S
T
U
V W X Y Z
A
Adding Processing Cores to the Hardware
Advanced Multi-queue settings
Affinity Settings
Allocating a Core for Heavy Logging
Allocating an Additional Core to the SND
Allocating Processing Cores
B
Basic Multi-queue Configuration
BIOS Settings
C
Command Line
Command Line Reference
Configuring CoreXL
Configuring IPv4 and IPv6 Firewall Instances
Connection Templates
CoreXL Administration
CoreXL for IPv6
cpconfig
D
Deciding if Multi-queue is needed
Default Configuration
Delayed Notification
Delayed Synchronization
E
Example
Example
Example
Example: fwaccel6 stat
Example: fwaccel6 stats
Example: fwaccel6 templates
F
fw ctl affinity
fw ctl affinity -l
fw ctl affinity -s
fw ctl multik stat
fwaccel
fwaccel stats and fwaccel6 stats
fwaccel6
fwaffinity.conf
fwaffinty_apply
G
Glossary of Terms
I
Increasing the Number of Concurrent Connections
Installing during a SecurePlatform Gateway Installation
Installing on Installed SecurePlatform Gateway with HFA
Installing on SecurePlatform Gateway
Introduction to Multi-Queue
Introduction to Performance Pack
M
Multi-Core Systems
Multi-queue
Multi-queue Administration
Multi-queue Requirements and Limitations
N
Network Interface Cards
Non-accelerated traffic analysis
O
Overriding rx queue and interface limitations
P
Performance Measurement
Performance Pack
Performance Troubleshooting
Performance Tuning
Performance Tuning and Measurement
Preparing the Performance Pack
proc entries
Processing Core Allocation
R
Restrictions
S
SecureXL NAT templates
SecureXL Templates
Setting Interface Affinities
Setting the fwd Daemon Affinity
Setting the Maximum Concurrent Connections
sim affinity
Special Scenarios and Configurations
Supported Features
Supported Platforms and Unsupported Features
Syntax
Syntax
Syntax
Syntax
T
TCP State and Benchmarking
Testing
The Sim Affinity Command
Troubleshooting
U
Upgrading with SmartUpdate
Upgrading with the Command Line