Adding a New VPN Site to an Exported Package

When you use an exported package, you can configure each package to connect to a default VPN site which you create.

By default, no VPN site is configured for a new package.

To add a new VPN site to an exported package:

1. Create a package or edit an export package. See .

2. In the Capabilities screen of the Create Export Package wizard, select the Remote Access VPN checkbox.

3. In the Virtual Groups and VPN Sites screen, in the VPN site section:

   1. To add a VPN site manually, select Manual:

      1. Click New and enter these:

         • Name - Unique name for this VPN site.

         • Site Address - Site IP address.

         • Authentication Method - One of these:

           • Username-password - Endpoint users authenticate using their VPN user name and password.

           • CAPI certificate - Endpoint users authenticate using the applicable certificate.

           • P12 certificate - Endpoint users authenticate using the applicable certificate.

           • SecurID KeyFob - Endpoint users authenticate using a KeyFob hard token.

           • SecurID PinPad -Endpoint users authenticate using the an SDTID token file and PIN.

           • Challenge-response - Endpoint users authenticate using an administrator supplied response string in response to the challenge prompt.

      2. Click OK.

   2. To add a VPN site by importing a .config file, select Import from file:

      1. Click Upload and select the .config file you want to upload.

         Note - Only .config file with a maximum file size of 1000 KB is supported.

      2. Click Next and continue with step i in Create an export package. See .