Configuring Egress Routing

This section describes the necessary steps to configure egress routing.

To configure egress routing:

1. Configure the Security Policy Collection of rules that control network traffic and enforce organization guidelines for data protection and access to resources with packet inspection. to allow internal VPC networks to the Internet.

   

2. Makes sure there is a correct outbound NAT policy setup.

   

3. Push the Policy.

4. Use an internal to host to test the outbound connectivity.

   1. Go to SmartConsole > navigate to Logs & Monitor.

   2. Check that traffic is distributed between both Check Point Gateways. This is because traffic is load balanced by Aviatrix Gateways.

      

For more information, see this tutorial video.