Network Link Configuration

Use the Network Link Configuration window to configure the network link settings for the LOM physical interface on the appliance:

1. Select Configuration > Network Link.

   The Network Link Configuration window opens.

2. Configure the network link settings for the LOM interface.

   Field	Description
   LAN Interface	Shows the interface that is used to connect to LOM. Note - This field does not exist in newer LOM Firmware versions.
   Auto Negotiation	When enabled, the Link Speed and Duplex Mode are set automatically. In order to operate LOM at 1 Gb, you must enable Auto Negotiation.
   Link Speed	Toggles the link speed to 10Mb or 100Mb to match your network environment. This option applies only in dedicated NIC mode and is not available if Auto Negotiation is set to On.
   Duplex Mode	Sets the Duplex Mode to Full or Half. This setting is not available if Auto Negotiation is set to On.

3. Click Save.