Appliance Installation

Rack Mount Shelf

Bottom view

Legend

Shelf Hole

Used for Appliance Installation
A Side by Side
B Middle

Single Appliance Installation

Note - A single appliance can only be installed in the middle of the shelf, not on the side.

  1. Place the shelf on a flat surface.

  2. Identify the location and holes to use for your appliance.

  3. Attach the appliance to the shelf using 2 black screws:

    Lift the shelf and insert the screw from underneath, through the hole next to the letter

  4. Line up the holes on the bottom of the appliance with the screws. Place the appliance on top of the screws and slide it forward until it locks into place.

  5. To secure the appliance, use a screwdriver (not included in kit) to tighten the screws on the bottom of the shelf. After the screws are fastened, the appliance is locked to the shelf.

Side by Side Appliance Installation

Follow the steps for a single appliance installation but place each appliance on one side of the shelf.

Appliance bottom view:

Installing the Industrial Power Adapter(s)

  1. Attach the DC jack of the adapter and plug into the appliance.

  2. Place the adapter in the correct position on the shelf and push it until you reach the stopper.

  3. Place a bracket over the top of the adapter and attach to the shelf on either side with the black screws.

  4. Use cable ties as needed to hold the cables in position. See (1) in diagram for location.

Uninstalling the appliance

Note - This applies to both single and side by side installations.

  1. Unplug the cable from the power adapters and the appliance.

  2. Loosen the screws from the adapter brackets and remove the brackets.

  3. Remove the adapters.

  4. Remove the appliance.

  5. Repeat steps 1-4 for the second appliance.