Configuring RIP in Clish

Use these commands to configure and view RIP properties for specific interfaces.

• To see the available "set" commands for RIP, enter in Clish:

  set rip[Space][Tab]

• To see the available "show" commands for RIP, enter in Clish:

  show rip[Space][Tab]

Note - Gaia Embedded does not have CLI commands for route filtering and route redistribution. You must configure inbound routing policies and redistribution of routes through the Portal. You can configure route maps and route aggregation using CLI commands. Route map configuration done through the CLI takes precedence over route filtering and redistribution configured in the Portal. For example, if RIP uses route maps for inbound filtering, anything configured on the page for inbound route filters for RIP is ignored. You can still use the Portal to configure route redistribution into RIP.

Best Practice - Do not configure RIP 1 and RIP 2 together.