Configuring OSPF in Clish

• To see the available "set" commands for OSPF, enter in Clish:

  set ospf[Space][Tab]

• To see the available "show" commands for OSPF, enter in Clish:

  show ospf[Space][Tab]

Note - Gaia Embedded does not have CLI commands for route filtering and redistribution. You must configure inbound routing policies and redistribution of routes in WebUI. You can configure route maps and route aggregation using CLI commands. Route map configuration done through the CLI takes precedence over route filtering and redistribution configured in the WebUI. For example, if OSPF uses route maps for inbound filtering, anything configured in the WebUI for inbound route filters for OSPF is ignored. You can still use the WebUI to configure route redistribution into OSPF.

Note - Starting in R81.10.05, it is supported to configure OSPF in the WebUI. See Configuring OSPF in WebUI

Workflow:

1. Configure the required OSPF settings. See the next sections.

2. Configure the rule to accept the OSPF traffic from the applicable routers:

   • For a Locally Managed appliance, see the Quantum Spark Appliances Locally Managed Administration Guide for your version (2000 models, 1900 models, 1800 models, 1600 models, 1500 models) > Chapter Appliance Configuration > Section Managing the Access Policy > Section Working with the Firewall Access Policy.

   • For a Centrally Managed appliance, see the:

     • Quantum Spark Appliances Centrally Managed Administration Guide for your version (2000 models, 1900 models, 1800 models, 1600 models, 1500 models) > Chapter Small-scale Deployment Installation > Section Creating the Security Policy.

     • Quantum Security Management Administration Guide for your version > Chapter Creating an Access Control Policy.