set internet-connection sdwan

In the R81.10.X releases, this command is available starting from the R81.10.10 version.

Description

Configures SD-WAN settings on the internet connection.

See:

Syntax

set internet-connection <Name>

      sdwan

            disabled

            enabled

                  download-speed <1-1000000>

                  override-circuit-id {on | off}

                  upload-speed <1-1000000>

      sdwan-backup {on | off}

      sdwan-ip-address-accessibility

            directly

            via-nat sdwan-nat-ip-address <NAT IPv4 address>

      sdwan-tag <Tag>

Parameters

Parameter

Description

internet-connection

Name of the Internet connection.

Press the TAB key to see the available options.

sdwan disabled

Disables the SD-WAN in this Internet connection.

sdwan enabled

Enables the SD-WAN in this Internet connection.

download-speed

Configures the SD-WAN interface download speed (Mbps).

override-circuit-id

Enables (on) or disables (off) the override of the SD-WAN interface Circuit ID.

The SD-WAN Policy assigns a Circuit ID automatically (to label the connections).

It is possible to override the assigned value.

Note - This parameter applies only when the appliance works in the Centrally Managed mode. See the Quantum SD-WAN Administration Guide.

upload-speed

Configures the SD-WAN interface upload speed (Mbps).

sdwan-backup

Configures this Internet connection as a backup in SD-WAN.

sdwan-ip-address-accessibility

Configures NAT for this Internet connection in SD-WAN:

Note - This parameter applies only when the appliance works in the Centrally Managed mode. See the Quantum SD-WAN Administration Guide.

  • directly

    Specifies that there is no NAT on the IP address of this interface.

    SD-WAN peers can connect to this IP address directly.

  • via-nat sdwan-nat-ip-address <NAT IPv4 address>

    Specifies that an external device or an ISP applies NAT on the IP address of this interface.

    Enter the applicable IP address after this external NAT, as the SD-WAN peers receive it.

sdwan-tag

Configures a desired interface tag.

Note - This parameter applies only when the appliance works in the Centrally Managed mode. See the Quantum SD-WAN Administration Guide.

Note - To delete an empty tag, run:

set internet-connection <Name> sdwan enabled sdwan-tag \

Example Command

set internet-connection Internet1 sdwan enabled upload-speed 100 sdwan-tag asd