fwaccel synatk state

In the R81.10.X releases, this command is available starting from the R81.10.00 version.

Description

The "fwaccel synatk state" and "fwaccel6 synatk state" commands control the Accelerated SYN Defender states.

The states are independent for IPv4 and IPv6.

Important - This command is not intended for end-user usage.

Transitions between states (Ready, Grace, and Active) occur automatically.

This command provides a way to force temporarily a state transition on an interface or group of interfaces.

Important - In a Cluster, you must configure all the Cluster Members in the same way.

Syntax for IPv4

fwaccel synatk state

      -h

      -a

      -d

      -g

      -i {all | external | internal | <Name of Interface>}

      -m

      -r

Syntax for IPv6

fwaccel6 synatk state

      -h

      -a

      -d

      -g

      -i {all | external | internal | <Name of Interface>}

      -m

      -r

Parameters

Important - You can specify only one of these parameters: -a, -d, -g, -m, or -r.

Parameter

Description

-h

Shows the applicable built-in usage.

-a

Sets the state to Active.

-d

Sets the state to Disabled.

-g

Sets the state to Grace.

-i all

Applies the change to all interfaces (this is the default).

-i external

Applies the change only to external interfaces.

-i internal

Applies the change only to internal interfaces.

-i <Name of Interface>

Applies the change to the specified interface.

-m

Sets the state to Monitor (Detect only) mode.

-r

Sets the state to Ready.