ClusterXL Configuration Commands - 'cphaconf'

Description

These commands configure internal behavior of the Clustering Mechanism in a Quantum Spark Cluster.

Notes:

You can run the "cphaconf" commands only in the Expert mode.
Run the "cphaconf" command to see all the available commands.
Syntax legend:
1. Curly brackets or braces { }:
  
  Enclose a list of available commands or parameters, separated by the vertical bar |, from which user can enter only one.
2. Angle brackets < >:
  
  Enclose a variable - a supported value user needs to specify explicitly.
3. Square brackets or brackets [ ]:
  
  Enclose an optional command or parameter, which user can also enter.
You can include these commands in scripts to run them automatically.

The meaning of each command is explained in the next sections.

List of the supported Expert mode "cphaconf" commands and the supported parameters

In the R81.10.X releases, this command is available starting from the R81.10.00 version.

cphaconf [-D] <options> start

cphaconf stop

cphaconf [-t <Sync IF 1>...] [-d <Non-Monitored IF 1>...] add

cphaconf clear-secured

cphaconf clear-non-monitored

cphaconf debug_data

cphaconf set_pnote -d <Device> -t <Timeout in sec> -s {ok | init | problem} [-p] register

cphaconf set_pnote -f <File> [-g] register

cphaconf set_pnote -d <Device> [-p] [-g] unregister

cphaconf set_pnote -a [-g] unregister

cphaconf set_pnote -d <Device> -s {ok | init | problem} [-g] report