set service-system-default SCCP
In the R81.10.X releases, this command is available starting from the R81.10.00 version.
Description
Configures settings of the built-in SCCP service object.
Syntax
|
|
Parameters
|
Parameter |
Description |
|---|---|
|
aggressive-aging-enable |
Enable to manage the connections table capacity and memory consumption of the Security Gateway. |
|
aggressive-aging-timeout |
Configures the time (in seconds) before the aggressive aging times out. |
|
delay-sync-interval |
In a cluster, configures the delay time (in seconds), after which the connection synchronization starts. |
|
disable-inspection |
Controls whether to disable deep inspection of traffic that matches this service. |
|
keep-connections-open-after-policy-installation |
Controls whether to keep the current connections after policy installation, even if these connections are not allowed by the new policy. |
|
port |
Configures the destination ports (a comma separated list of ports/ranges). |
|
session-timeout |
Configures the time (in seconds) before the session times out. |
|
source-port |
Configures the source port. |
|
sync-connections-on-cluster |
In a cluster, controls whether to synchronize connections with this service. |
|
sync-delay-enable |
True to delay connections synchronization |
|
use-source-port |
Controls whether to use the source port. |
Example Command
|
|