Configuring OSPF in Gaia Clish

• To see the available "set" commands for OSPF, enter in Gaia Clish:

  set ospf[Space][Tab]

• To see the available "show" commands for OSPF, enter in Gaia Clish:

  show ospf[Space][Tab]

Note - Gaia Embedded does not have CLI commands for route filtering and redistribution. You must configure inbound routing policies and redistribution of routes through the Portal. You can configure route maps and route aggregation using CLI commands. Route map configuration done through the CLI takes precedence over route filtering and redistribution configured in the Portal. For example if OSPF uses route maps for inbound filtering, anything configured on the Portal page for inbound route filters for OSPF is ignored. You can still use the Portal to configure route redistribution into OSPF.

Workflow:

1. Configure the required OSPF settings. See the next sections.

2. Configure the rule to accept the OSPF traffic from the applicable routers:

   • For a Locally Managed appliance, see the Quantum Spark Appliances Locally Managed Administration Guide for your version > Chapter Appliance Configuration > Section Managing the Access Policy > Section Working with the Firewall Access Policy.

   • For a Centrally Managed appliance, see the:

     • Quantum Spark Appliances Centrally Managed Administration Guide for your version > Chapter Small-scale Deployment Installation > Section Creating the Security Policy.

     • Quantum Security Management Administration Guide for your version > Chapter Creating an Access Control Policy.