First Time Configuration Wizard

To configure the Check Point Appliance for the first time after you complete the hardware setup, use the First Time Configuration Wizard.

WiFi models with a special device label only:

If you did not yet run the First Time Configuration Wizard, you can connect through WiFi using the SSID and WiFi password that appears on the sticker. This is unique for each appliance.

The wizard will run again the next time you connect to the appliance if you do not complete the wizard for one of these reasons:

• The browser window is closed.

• The appliance is restarted while you run the wizard.

After you complete the wizard, you can use the WebUI (web user interface) to change settings configured with the First Time Configuration Wizard and to configure advanced settings.

To open the WebUI, enter one of these addresses in the Web browser:

• https://my.firewall

• https://192.168.1.1:4434

When you run the wizard, click Quit to save configured settings.

If a security warning shows, confirm it and continue.

The pages that show in the wizard depend on your appliance model and the options you select.

The First Time Configuration Wizard starts.