Advanced Settings

The Device > Advanced Settings page is for advanced administrators or Check Point Support. You can configure values for multiple advanced settings for the various blades.

Important - Changing these advanced settings without fully understanding them can be harmful to the stability, security, and performance of this appliance. Continue only if you are certain that you understand the required changes.

To configure the serial port and web interface settings attributes, see the below table. To learn more about the other attributes, see the appliance Administration Guide and the R80.20.20 home page.

For further details regarding the attributes, consult with Check Point Support when necessary.

To filter the list of attributes:

  1. Enter text in the Type to filter field.

    The search results are dynamically shown as you type.

  2. To cancel the filter, click X next to the search string.

To configure the appliance attributes:

  1. Select an attribute.

  2. Click Edit.

    The attribute window opens.

  3. Configure the settings, or click Restore Defaults to reset the attribute to the default settings. For more details on the attributes, see the next sections. 

  4. Click Apply.

To reset all the appliance attributes to the default settings:

  1. From the Advanced Settings window, click Restore Defaults.

    The Confirm window opens.

  2. Click Yes.

All appliance attributes are reset to the default settings.

 

Table: Additional Information for Attributes

Attribute

 

Description

Serial port

Enable serial port

Flow control Mode

Mode port speed

With the serial port parameters you can configure the console port on the back panel of the appliance.

You can disable it completely (clear the Enable serial port checkbox) if necessary and configure port speed and flow control settings. Note that these settings must match the configuration of the device connected to the console port.

There are the modes for this port:

  • Console - This is the default mode configured. The port is used to access the appliance's console.

  • Active - Instead of connecting through the port to the appliance's console, the data is relayed to a specified telnet server which can now be viewed through this port. Enter the Server TCP port of the telnet server and the IP address of the server. Two different IP server IP addresses can be configured (Primary server and Secondary server).

  • Passive - In this mode the flow of data is reversed and the appliance connects through the serial port to the console of the connected device. This console is accessible through a telnet connection to a configured port on the appliance. In Listen on TCP port, enter the port number.

To configure an implicit rule that allows traffic from any source to this port, make sure Implicitly allow traffic to this port is selected. If you do not create an implicit rule, you must manually define an access rule in the Firewall Rule Base.

Two appliances, one in active mode and the other in passive mode, can allow a client to remotely connect to a console connected to the appliance in passive mode over the internet using a telnet connection.

Web Interface Settings and Customizations

Company URL

Use a company logo

Select Use a company logo in the appliance's web interface to display a different logo (not the Check Point default logo).

In Company logo, click the Upload company logo link, browse to the logo file, and click Apply.

In Company URL, enter the company's URL. When you click the company logo in the web interface it opens this URL.