Upgrade Using Boot Loader

To upgrade the Check Point Appliance using U-boot (boot loader):

Note - In 1590, Bootloader is supported only through the DMZ port and is not available through the LAN ports.

1. Connect to the appliance with a console connection (use the serial console connection on the back panel of the appliance), boot the appliance and press CTRL+C. The Gaia Embedded Boot Menu is shown.

2. Press 5 to select Install/Update Image/Boot-Loader from Network.

3. You are asked if you want to manually load the image from a TFTP server, or if you want to use automatic mode with a bootp server.

4. If you select manual mode, you are asked to fill in the IP of the Check Point Appliance, the IP of the TFTP server, and the image name.

5. If you select automatic mode, the procedure starts automatically to search for the bootp server.

6. While in menu mode, press CTRL+C again to return to the Boot Loader menu.

   During the upgrade, the Power LED blinks blue to indicate progress. This takes up to a minute.

   When the LED turns a solid blue, the appliance is ready for login.

   Note – The LED is red if there is an alert or error.