SNMP for Maestro Orchestrators

You can use SNMP to monitor different aspects of the Quantum Maestro Orchestrator:

  • Software versions

  • Key performance indicators

Notes:

Prerequisites

Step

Instructions

1

On the Quantum Maestro Orchestrator, in Gaia Portal or Gaia gClish:

  1. Enable the SNMP Agent.

  2. Configure SNMP settings.

    Best Practice - Use only SNMP v3.

See the R82 Gaia Administration Guide > Chapter "System Management" > Section "SNMP".

2

Upload these Check Point MIB files from the Security Group to your third-party SNMP monitoring software:

  • The SNMP MIB file:

    $CPDIR/lib/snmp/chkpnt.mib

  • The SNMP Trap MIB file:

    $CPDIR/lib/snmp/chkpnt-trap.mib

    (The /etc/snmp/GaiaTrapsMIB.mib file is not supported.)

Supported SNMP OIDs for Maestro Orchestrators

Only these OID branches are supported:

Branch

OID

svn

Numerical

.1.3.6.1.4.1.2620.1.6

Full Text

.iso.org.dod.internet.private.enterprises.checkpoint.products.svn

mngmt

Numerical

.1.3.6.1.4.1.2620.1.7

Full Text

.iso.org.dod.internet.private.enterprises.checkpoint.products.mngmt

Supported SNMP Trap OIDs for Maestro Orchestrators

Only these OID branches are supported:

Branch

OID

chkpntTrapInfo

Numerical

.1.3.6.1.4.1.2620.1.2000.0

Full Text

.iso.org.dod.internet.private.enterprises.checkpoint.products.chkpntTrap.chkpntTrapInfo

chkpntTrapNet

Numerical

.1.3.6.1.4.1.2620.1.2000.1

Full Text

.iso.org.dod.internet.private.enterprises.checkpoint.products.chkpntTrap.chkpntTrapNet

chkpntTrapDisk

Numerical

.1.3.6.1.4.1.2620.1.2000.2

Full Text

.iso.org.dod.internet.private.enterprises.checkpoint.products.chkpntTrap.chkpntTrapDisk

chkpntTrapCPU

Numerical

.1.3.6.1.4.1.2620.1.2000.3

Full Text

.iso.org.dod.internet.private.enterprises.checkpoint.products.chkpntTrap.chkpntTrapCPU

chkpntTrapMemory

Numerical

.1.3.6.1.4.1.2620.1.2000.4

Full Text

.iso.org.dod.internet.private.enterprises.checkpoint.products.chkpntTrap.chkpntTrapMemory

Notes:

  • The /etc/snmp/GaiaTrapsMIB.mib file is not supported.

  • The "set snmp traps" command is not supported.