Log and Configuration Files in Maestro

This section describes some log and configuration files you can examine during the troubleshooting.

Files on Security Group Members in Security Groups

Feature	File
Additional cluster information	`$FWDIR/log/cpha_policy.log.*`
All logs that do not have a dedicated log file	`/var/log/junk.log.dbg`
Command auditing	`/var/log/asgaudit.log*`
CPD daemon	`$CPDIR/log/cpd.elg`
Discovering the hardware components	`/var/log/start_linker.log.dbg`
Distribution	`/var/log/dist_mode.log*`
Dividing physical interfaces to slave BackPlane interfaces and assembling the bond (BPEth) interfaces	`/var/log/start_tor_sgm.log.dbg` `/var/log/start_bfm.log.dbg`
Dynamic Routing	`/var/log/routed.log`
Early boot configuration cloning	`/var/log/image_clone.log.dbg`
Expert mode shell auditing	`/var/log/command_logger.log*`
FWD daemon	`$FWDIR/log/fwd.elg`
FWK daemon (VSX information)	`$FWDIR/log/fwk.elg.*` (in the context of each Virtual System)
Gaia Alerts	`/var/log/send_alert.*`
Gaia Clish auditing	`/var/log/auditlog*`
Gaia First Time Configuration Wizard	`/var/log/ftw_install.log`
Gaia OS installation	`/var/log/anaconda.log`
General log file	`/var/log/messages*`
Information about the dedicated Sync interfaces	`/var/log/start_smo.log.dbg`
LLDP updates	`/var/log/smartd.log.dbg` Also, run the `lldpneighbors` command
Log Servers	`/var/log/log_servers*`
Pulling the Security Group configuration, rebooting, cluster configuration	`$FWDIR/log/blade_config.*`
Reboot logs	`/var/log/reboot.log`
Security Group installation	`/var/log/start_mbs.log`
Silent install when adding a new Security Group Member to an existing Security Group	`/var/log/silent_install.log.dbg`
Synchronization of the new configuration to the Gaia database	`/var/log/start_smo_1.log.dbg`
VPND daemon	`$FWDIR/log/vpnd.elg*`

Files on Quantum Maestro Orchestrators

Feature	File
All logs that do not have a dedicated log file	`/var/log/junk.log.dbg`
Applying Security Group configuration	`/var/log/ssm_sg.log.dbg`
Configuring the SDK	`/var/log/messages`
Information about Security Groups	`/etc/sgdb.json`
Information about detected Security Group Members	`/etc/rsrcdb.json`
LLDP updates	`/var/log/smartd.log.dbg` Also, run the `lldpctl` command
Starting of the SDK	`/var/log/start_tor_ssm.log.dbg`