How Dual Chassis Active/Standby Mode Works

Background

The Dual Chassis High Availability mechanism is based on two identical Scalable Chassis.

One Scalable Chassis handles traffic (Active state), while the other Scalable Chassis is in the Standby state.

The Standby Chassis synchronizes with the Active Chassis, so that traffic continues uninterrupted when there is a Chassis failover.

  • Chassis High Availability works on the principle that the Scalable Chassis with the highest quality grade becomes the Active Chassis.

    To make sure that the most reliable Chassis is Active, each Chassis is assigned a quality grade.

    The quality grade is based on a continuous monitoring of Chassis critical components and traffic characteristics.

    Automatic failover occurs only when the quality grade of the Standby Chassis is greater than the quality grade of the Active Chassis, plus the minimum differential.

    A configurable minimum grade differential prevents unnecessary failover, which can cause performance degradation.

    See:

  • Each Chassis port has its own unique MAC address.

    The MAC addresses for SGMs are the same on the same Chassis.

    The MAC addresses are different for the ports on the two Chassis.

    A Chassis failover event sends GARP / ICMPv6 packets for each interface. This informs the network to use the other interfaces.

    See Working with the GARP Chunk Mechanism.

With the applicable Gaia gClish commands, you configure these High Availability parameters:

  • Chassis High Availability - "Active Up" Mode or "Primary Up" Mode.

  • Chassis quality grade factors

  • Failover grade difference for failover

  • Failover freeze interval

  • Port priority

Configuring Dual Chassis Active/Standby Mode

Syntax

set cluster configuration high-availability mode <Mode ID>

Available Modes

Mode ID

Mode Title

Mode Description

0

Active/Standby - Active Up

No primary Chassis.

The currently Active Chassis stays Active unless it goes DOWN, or the Standby Chassis has a higher Chassis quality grade.

1

Active/Standby - Primary Up

Active Chassis always stays Active unless it goes DOWN, or the Standby Chassis has a higher Chassis quality grade.

See Configuring the Chassis Priority.

2

Not available

Not supported.

3

Standby Chassis VSLS Mode

In the Legacy VSX mode, provides Virtual System Load Sharing.

Synchronizing Dual Chassis on a Wide Area Network

You can install your Chassis at two different remote sites as a geographically distributed cluster.

There are two limitations to this capability:

  1. The synchronization network must guarantee no more than 100ms latency and no more than 5% packet loss.

  2. The synchronization network can include switches and hubs.

    Routers cannot be installed on the synchronization network because they drop Cluster Control Protocol packets.