show cluster vsls

This command is supported only on these:

  • Maestro Security Group in the Traditional VSX mode

  • Scalable Chassis Security Group in the Traditional VSX mode

Note - You must run this command in Gaia gClish.

Description

Shows cluster configuration - in the Traditional VSX mode, shows the Virtual System Load Sharing (VSLS) settings.

Syntax

show cluster vsls<ESC><ESC>

show cluster vsls

      member_ratio

      system

            mgmt_monitoring

            primary_site

Parameters

Parameter

Description

member_ratio

Shows the VSLS cluster member ratio.

system mgmt_monitoring

Shows which Virtual Systems monitor the Management Port link state:

  • VS0_only

    Only VS0 monitors the link state of the Management Port.

    Failover occurs only for VS0 and the SMO.

  • all_VSs

    All Virtual Systems decide their state based on link state of the Management Port.

    Failover occurs for all Virtual Systems.

system primary_site

Shows the VSLS Primary Site:

  • 0 - The Security Group decides automatically, based on the Virtual System ID.

  • 1 - Site 1 is the primary Site.

  • 2 - Site 2 is the primary Site.

Related Commands