set smo
This command is supported only on these:
|
|
Note - You must run this command in Gaia gClish. |
Description
Configures settings related to the Single Management Object (SMO) on the Security Group.
|
Important - Do not use this command, unless Check Point Support or an Administration Guide explicitly tells you to do so. |
Related Commands
Syntax
|
Commands
Command |
Description |
---|---|
|
Enables or disables the audit logs for SMO operations in the Expert mode. |
|
On a Maestro Security Group with different Security Appliances, configures weights for Security Group Members to balance the traffic proportionally. See Configuring Weights for Security Group Members in Maestro. |
|
Configures the number of Sites in a Security Group. |
|
Enables the synchronization of user-defined files from the SMO. You must configure the required files with the "add smo" command. |