orchd

This command is supported only on:

  • Maestro Orchestrator

Note - You must run this command in the Expert mode

Description

Controls the main daemon (orchd) on the Maestro Orchestrator.

Warning - No traffic flows through the Maestro Orchestrator until this daemon starts.

Related Commands

Syntax

orchd help

orchd

      activate

      restart

      start

      status

      stop

Parameters

Parameter

Description

--help

Shows the built-in help.

activate

Activate the Maestro Orchestrator.

To enable the Uplink ports and the required daemons, you must manually activate your Orchestrator in these cases:

  • If you performed a clean install.

  • You restored the Orchestrator to its factory defaults.

For more information, see sk171784.

restart

Restarts the daemon.

start

Starts the daemon.

status

Shows the status of the daemon (up or down).

stop

Stops the daemon.