CloudGuard Controller Command Line Interface

Note - For other commands, see the R82 CLI Reference Guide.

The "vsec_controller_cli" command allows resending all the enforcement data to a Security GatewayClosed Dedicated Check Point server that runs Check Point software to inspect traffic and enforce Security Policies for connected network resources. you select from a list for troubleshooting purposes.

Step

Instructions

1

Connect to the command line on the Management ServerClosed Check Point Single-Domain Security Management Server or a Multi-Domain Security Management Server..

 

Log in to the Gaia ClishClosed The name of the default command line shell in Check Point Gaia operating system. This is a restricted shell (role-based administration controls the number of commands available in the shell)., or Expert mode.

2

Run:

vsec_controller_cli

3

Select:

Resend enforcement data to gateway.

4

Select the Security Gateway to reset.

Note - If data is not synchronized after reset, contact your Check Point partner, or Check Point Support.