pdp control

Description

Provides commands to control the PDP.

Syntax

pdp control

      revoke_ip <IP address>

      sync

Important:

  • In a Cluster, you must configure all the Cluster Members in the same way.

  • On Scalable Platforms (Maestro and Chassis), you must run the applicable commands in the Expert mode on the applicable Security Group.

  • In the VSNext / Legacy VSX mode, you must run the applicable commands in to the context of the applicable Virtual Gateway / Legacy Virtual System (vsenv <VS ID>).

Parameters

Parameter

Description

revoke_ip <IP address>

Logs out the session that is related to the specified IP address.

sync

Forces an initiated synchronization operation between the PDPs and the PEPs.

When you run this command, the PDP informs its related PEPs of the up-to-date information of all connected sessions.

At the end of this operation, the PDP and the PEPs contain the same and latest session information.