asg_dxl
|
|
Warning - Do not use this command to change the configuration, unless Check Point Support explicitly asked you to do so. |
|
|
Best Practice - Follow the instructions in Working with the Distribution Mode. |
|
This command is supported only on these:
|
|
|
Note - You can run this command in Gaia gClish or in the Expert mode. |
Description
Shows and configures the distribution mode (DXL) options.
The distribution mode are (for more information, see Working with the Distribution Mode.):
|
Mode Number |
Mode Name |
Packet Assignment to a Security Group Member |
||
|---|---|---|---|---|
|
0 |
General |
The ElasticXL Cluster / Maestro Orchestrators assign packets to a Security Group Member based only on the packet's Source IP address and the Destination IP address. If Layer 4 distribution is enabled, the ElasticXL Cluster / Maestro Orchestrators assign packets to a Security Group Member based on the packet's Source IP address, Source Port, Destination IP address, and Destination Port. |
||
|
1 |
User (Internal) |
Packets are assigned to a Security Group Member based only on the packet's Destination IP address. If Layer 4 distribution is enabled, the ElasticXL Cluster / Maestro Orchestrator assigns packets to a Security Group Member based on the packet's Source Port and the Destination IP address.
|
||
|
2 |
Network (External) |
Packets are assigned to a Security Group Member based only on the packet's Source IP address. If Layer 4 distribution is enabled, the ElasticXL Cluster / Maestro Orchestrator assigns packets to a Security Group Member based on the packet's Source IP address and Destination Port.
|
Syntax
Run the "asg_dxl" command or the "asg dxl" command.
|
|
Parameters
|
Parameter |
Description |
||
|---|---|---|---|
|
No Parameters |
Shows the built-in help. |
||
|
|
Shows the built-in help. |
||
|
|
Shows the verbose built-in help (shows more sub-commands). |
||
|
|
Shows the Base MAC Address for each Site. |
||
|
|
Calculates the DXL decision based on these parameters:
|
||
|
|
Show or configures the distribution mode. The parameter " |
||
|
|
Exports the DXL configuration to the specified file. |
||
|
|
Shows the status of the DXL "General" mode (enabled or disabled). |
||
|
|
Imports the DXL configuration from the specified file. |
||
|
|
Initializes the DXL configuration. |
||
|
|
Shows the status of the DXL "Layer 4" mode (enabled or disabled). |
||
|
|
Analyzes the load of the Security Group.
|
||
|
|
Calculate the MD5 sum of the DXL configuration. |
||
|
|
Shows the DXL decision for the specified 5-tuple that currently exists in the "Connections" kernel table. |
||
|
|
Shows the size of the DXL table. |
||
|
|
Shows the DXL status - summarized or verbose. |
||
|
|
Controls the manual assignment of the distribution list:
|
||
|
|
Forces the DXL update. |
||
|
|
Compare the configuration signatures between the SSMs and the DXL distribution. |